1、電蒸汽鍋爐http://www.tsgspipe.cn/與軟水器連接的管道應采用給水塑料管，排水管不得采用軟塑料管，防止管道變形，影響排水效果。
Electric steam boiler pipes connected with a water softener should be used plastic water pipes, drains should not be used flexible plastic tubing, to prevent pipeline deformation, affecting drainage effect.

2、按照電蒸汽鍋爐控制閥進出水箭頭標記連接進出水管，采用流量型再生控制器，流量計必須安裝在出水口。
An electric steam boiler control valve out of the water inlet and outlet pipe connected to the arrow mark, the use of flow-type regeneration controller, flowmeters must be installed in the outlet.

3、電蒸汽鍋爐進出水管應裝有壓力表及手動閥門，同時還應裝有旁通閥，在出水管閥前還應安裝有取樣閥。進水管閥后一般安裝有Y型過濾器，防止管道內污物堵塞閥體造成設備無法正常運行。
Electric steam boilers out of the pipe should be fitted with pressure gauges and manual valves, but also be equipped with a bypass valve in the outlet pipe valve should be installed before sampling valve. After the inlet valve is usually equipped with a Y-type filter to prevent dirt clogging the pipeline valve cause the device to not function properly.

4、電蒸汽鍋爐排水管的連接長度不應超過6m，盡量減少彎度，并嚴禁安裝閥門。
Electric steam boiler drain connection length should not exceed 6m, to minimize camber, and are prohibited from installing the valve.

5、電蒸汽鍋爐http://www.tsgspipe.cn/鹽水管路連接長度不應超過2m，一定要保持良好的密封性，否則會影響軟水器的再生效果。
Electric steam boilers brine pipeline connection length should not exceed 2m, we must maintain a good seal, otherwise it will affect the regeneration softener.